Following the solution bellow, you may troubleshoot the issue that Cannon WUX5800 Projector can’t join network.
The causes that Cannon WUX5800 Projector can’t join network and its solution
Cause 1: The LAN cable (shielded twisted pair) is not connected correctly.
Check whether the LAN cable (shielded twisted pair) is connected to the projector correctly.
Cause 2: The projector has not been on long enough (less than about 40 seconds).
Network functions are not available until about 40 seconds after the projector is plugged in. Wait at least 40 seconds, and then try to connect again.
Cause 3: The projector cannot join a wireless network.
Follow the instructions in “Network Setting”=> “Wireless LAN (Wi-Fi)” =>“Detailed settings (wireless)” to set up the projector again. In PJ AP mode, try changing the wireless channel on the projector. In infrastructure mode, try changing the wireless channel on the access point.
Read more:
- Cannon WUX5800 Projector Marginal Focus Reseting Guide
- How to Adjust Image for Tabletop or Floor Installation of Cannon WUX5800 Projector?
- How to Use Lens Shift on Cannon WUX5800 Projector?
- Projecting Images from a USB Flash Drive on Cannon WUX5800 Projector
- How to Install/Remove Lens Unit of Cannon WUX5800 Projector?
